Minolta QuickScan 35 User Manual page 16

If the QuickScan 35 Plus is in the middle of the SCSI chain
You may require a different connector to link the QuickScan 35 Plus to your SCSI chain, see your dealer for
the appropriate SCSI connectors.
Before starting, turn the computer and all connected devices OFF.
1. Plug the 50 pin half pitch end of the SCSI cable into the open SCSI port on the rear panel of your
QuickScan 35 Plus, then plug the other end of the SCSI cable into the SCSI port on the rear of the
PC, or the next device in the SCSI chain.
• Either SCSI port can be used, there is no dedicated IN or OUT port.
2. Plug the SCSI cable from the next device in your SCSI chain into the open port on the back of the
QuickScan 35 Plus.
16
QuickScan 35