Resetting The Print Server Parameters - SEH SEH650 User Manual

3.5 Resetting the Print Server Parameters

BaseLine Print Server User Manual
Only by using the status button can the parameters be reset without
entering the password. This action, however, will delete all
parameters, including for example, the IP address.
You must reset the parameters, for example, if you want to use the
print server in another network by changing the location of the
printer. Before this change of location, you should reset the
parameters to their default settings to install the print server in
another network.
Proceed as follows:
1. Disconnect the power socket on the print server.
2. Keep the status button pressed.
3. Turn the printer on. Reconnect the power socket on the print
server.
Both LEDs blink rapidly.
4. Release the status button within five seconds.
The LEDs blink alternatingly.
5. Press the status button again.
The parameters are reset. The yellow LED then blinks
regularly.
6. Disconnect and reconnect the power socket on the print server.
Resetting the Print Server Parameters
3-7