Operating And Safety Tips; Cleaning & Maintenance - Wilfa WBL-350S Operating Instructions Manual

Important: The blender comes with a thermal non-resettable fuse feature to
prevent damage to the motor in the case of extreme overload. If the unit stops
unexpectedly, disconnect the device from the power outlet and let it cool for at
least 15 minutes before continuing.

OPERATING AND SAFETY TIPS

• It is recommended to cut ingredients into smaller pieces before them into the
jar. Avoid overload of the appliance by not operate the machine with large
quantities of food at the same time.
• Use a rubber or plastic spatula as needed, only when the blender is turned off.
Do not use any utensil inside the blender while motor is on.
• Never use metal utensils, as damage may occur to the jar, cup or cutting
assembly.
• The jar, sport bottle and travel cups are not recommended for microwave use.
CLEANING & MAINTENANCE
Note: We recommend to wash the parts by hand. If using dishwasher, place
accessories on top rack and use maximum 50 degree Celsius. Always unplug your
appliance from the electrical outlet before performing manual cleaning.
Tips: Quick wash the parts by adding a small amount of liquid detergent into
a half full cup of clean tap water. Make sure that you have mounted lid/cups
correct before you start. Run pulse mode for 15 seconds and repeat procedure if
necessary, rinse and dry all parts thoroughly. If further cleaning is needed, please
follow the steps below for manual cleaning.
1. Disconnect the appliance from the power outlet.
2. Remove the jar/cups from the motor unit.
3. Disassemble any detachable accessories.
4. Clean all removable parts with a dish brush in soapy lukewarm water. Rinse and
dry all parts thoroughly.
5. Wipe the motor unit with a damp cloth and dry thoroughly. Note: Never
submerge the motor base in water or other liquids, or place in a dishwasher.
6. Store the unit on a flat and dry surface.
11