Minolta PageWorks Pro 18 User Manual page 53

3
With one hand holding the duplex unit in position, use a Phillips
screwdriver to tighten the screws that are permanently attached to
the back of the duplex unit.
Note
• Hold up the duplex unit with your hand during installation until it is
secured to the printer with the screws.
4
Connect the power cord to the printer and then turn the printer on.
See "Connecting the Power Cord", page 2-9.
See "Turning On the Printer", page 2-12.
5
Generate a configuration page to verify that duplex unit is listed
under the Printer Configuration item.
See "Testing the Printer", page 2-13.
PRINTER CONFIGURATION
Tray 2 = Not Installed
Tray 3 = Not Installed
Duplex Unit = Installed
PostScript = Not Installed
Network Card = Not Installed
Options
2-23