Table of Contents
Advertisement
or any connected apparatus.
4. ALWAYS make sure that your hands, work area, and instruments are clean
and dry before making any connections or operating the power supply.
5. ONLY connect the power cord to a properly grounded AC outlet.
Avoiding Damage to the Instrument
1. Do not attempt to operate the device if damage is suspected.
2. Protect this unit from physical damage, corrosive agents and extreme
temperatures (direct sunlight, etc.).
3. For proper ventilation and safety concerns, keep at least 10 cm of space
behind the instrument, and at least 5 cm of space on each side.
4. Use high level of precaution against the damages on the unit.
5. Do not operate the unit out of environmental conditions addressed
above.
6. Prior to applying any cleaning or decontamination methods other than
equipment.
Equipment Operation
Follow the guidelines below to ensure safe operation of the unit:
1. Check the displayed figures to see if the unit is functioning correctly before
using this unit.
2. NEVER access dangerous chemicals or other materials to prevent possible
hazard of explosion and damage.
3. A temporary conductivity caused by condensation might occur even though
this series is rated Pollution Degree 2 in accordance with IEC 664.
To Disposal UV tubes
The UV tubes contain mercury; please dispose of the tubes in accordance with
local laws. It is important to handle the waste tubes with care to ensure public
health and the environment. For further information about recycle waste tubes,
please see www.lamprecycle.org.
Equipment Handling
Follow the guidelines below to ensure safe move of the device:
1. Carry the device at least two people.
2. Do not over than knuckle height when you moving the device.
3. Move the device by cart and assist the device do not drop.
7
Advertisement
Table of Contents
