Table of Contents
Advertisement
Major Science SmartView Pro Imager System series has been tested and
found to comply with the limits for the CE regulation. Also, SmartView Pro
Imager System series is RoHS compliant to deliver confident product which
meets the environmental directive. These limits are designed to provide
reasonable protection against harmful interference when the instrument series
is operated in a commercial environment. This instrument series used together
with power supply unit generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
instrument series in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at their expense.
Changes or modifications not expressly approved by the party responsible for
complianc
strongly recommended for the user to read the following points carefully before
operating this equipment.
1.
Read and follow the manual instructions carefully.
2.
Do not alter the equipment. Failure to follow these directions could result
in personal and/or laboratory hazards, as well as invalidate equipment
warranty.
3.
Use a properly grounded electrical outlet with correct voltage and current
handling capacity.
4.
Disconnect from power supply before maintenance and servicing. Refer
servicing to qualified personnel.
5.
Never use this instrument series without having the safety cover correctly
in position.
6.
Do not use the unit if there is any sign of damage to the external tank or
cover. Replace damaged parts.
7.
Do not use in the presence of flammable or combustible material; fire or
explosion may result. This device contains components which may ignite
such materials.
8.
Refer maintenance and servicing to qualified personnel.
9.
Ensure that the system is connected to electrical service according to
local and national electrical codes. Failure to make a proper connection
may create fire or shock hazard.
10. Use appropriate materials and operate correctly to avoid possible hazards
of explosion, implosion or release of toxic or flammable gases arising from
overheated materials.
11. The instrument is intended for scientific research use only, and must be
5
Advertisement
Table of Contents
