Major Science SmartView Pro 1100 Instruction Manual page 7

operated by qualified personnel who realize the potential risks of the use
of this instrument. Major Science makes no claim that its instruments are
designed or certified as medical device; no presentation, promises,
express warranty or implied warranty will be made concerning the
suitability of these instruments for any medical use. Major Science will not
provide customers any notice or certification concerning its products being
compliant as a medical device.
Safety Information
Use high level of precaution against any electrical device. Before connecting
the electrical supply, check to see if the supply voltage is within the range
stated at the rating label, and see to it that the device be seated firmly. Place
the unit in a safe and dry location; it must NOT touch the surrounding. Follow
the safety precautions for chemicals / dangerous materials. If needed, please
contact qualified service representative or
Environmental Conditions
Ensure the instrument is installed and operated strictly in the following
conditions:
1. Indoor use only
2. (non-condensing)
3. 75 kPa 106 kPa
4. Altitude must not exceed 2000 meters
5. Ambient to 40°C operating temperature
6. Pollution degree: 2
7. Mains supply voltage fluctuations up to ±10% of the normal voltage
Avoiding Electrical Shock
Follow the guidelines below to ensure safe operation of the unit.
SmartView Pro Imager System series has been designed to use with shielded
wires thus minimizing any potential shock hazard to the user. Major Science
recommends against the use of unshielded wires.
To avoid electrical shock:
1. In the event of solution accidentally spilling into the instrument, it must be
dried out for a period of time (at least 2 hours) and restored to NORMAL
CONDITION before each operation.
2. Never connect or disconnect wires loading from the power jacks when the
red indicator light of power switch is on.
3. WAIT at least 5 seconds after stopping a run before handling output leads
service@majorsci.com
6