Laser Safety Label—CDRH Requirement
Use of controls, adjustments, or performance other than those specified in this
CAUTION:
manual may result in hazardous radiation exposure
This is a semiconductor laser. The maximum power of the laser diode is 5 mW, and the wavelength is
770–795 nm.
International Notices—Power Cord
The following power cord requirements are in effect for your 220 V printer.
2
Minimum: 0.75 mm
Minimum: H05 VV - F
The male plug is certified in the country in which the equipment is to be installed, and the female plug is an
IEC 60320 connector.
International Notices—Voltage
Attention Norwegian users: This equipment is designed to operate within an IT power system where the
line-to-line voltage does not exceed 240 V.
Ozone Release
During printer operation, a small quantity of ozone is released. This amount is not large enough to harm
anyone. However, be sure the room where the printer is being used has adequate ventilation, especially if
you are printing a high volume of materials, or if the machine is being used continuously over a long
period.
28
.
Safety Information