Networking Your Printer; Connecting To A Wireless Network; Before You Connect; Connecting To A Wireless Network Using The Wi-Fi Setup Wizard - Kodak OFFICE HERO 6.1 Extended User Manual

2

Networking Your Printer

Connecting to a wireless network

Before you connect

Connecting to a wireless network using the Wi-Fi Setup Wizard

Connecting to a non-WPS wireless router
This section explains how to configure or change your wireless network settings.
To connect your printer to an 802.11b/g/n wireless (Wi-Fi) network, refer to the
following information.
You need:
• a wireless router.
• to determine whether your wireless router supports Wi-Fi Protected Setup
(WPS).
NOTE: If you have specific questions about your router, see your router
manufacturer's documentation for more information.
You can use the Wi-Fi Setup Wizard on the printer to connect to your wireless
network. Use the procedures that is appropriate for your network setup.
To connect your printer to your wireless network, you need to know the network
name, also called the Service Set Identifier (SSID). You can obtain your network
name from the wireless router. See the manufacturer's documentation for more
information.
If you have enabled security on your network, you also need to know the security
string (passphrase or password), which may be a Wired Equivalent Privacy (WEP)
or a Wi-Fi Protected Access (WPA/WPA2) passphrase.
Record your network information using the correct uppercase and lowercase letters.
Network Name (SSID): ________________________________________
Security String (case-sensitive): ________________________________
1. Press Home.
2. Press to select Network Settings, then press OK.
3. With Wi-Fi Setup Wizard selected, press OK.
NOTE: The Wi-Fi radio turns on when you select Wi-Fi Setup Wizard.
www.kodak.com/go/aiosupport 7