Features - PRIMERGY Econel 230R S1 Operating Manual

Features

1.2 Features
System board
The features of the system board are described in the technical manual for the
system board D2440 for the hardware and in the "BIOS Setup" for the firmware
(see "Literature" on page
Hard disk drives
The server is available in two basic variants: equipped with either EasyChange
hard disk drives or hot-plug hard disk modules.
– Variant with EasyChange hard disk drives:
The server includes two drive cages, in which up to six (2x3) SATA hard disk
drives have been fitted in "EasyChange" drive frames, with a maximum
height of 1 inch. There is a wire connection to the controller. Defective hard
disk drives cannot be replaced during operation.
– Variant with hot-plug hard disk modules:
The server includes two drive cages with up to six (2x3)
SAS/SATA hard disk modules. Each hard disk module can accommodate an
SAS/SATA hard disk drive with a maximum height of 1 inch. The module is
connected to the SAS backplane without cables. This allows hard disk drive
modules to be simply plugged in or pulled out (for further details see
plug hard disk drives" on page
If the server has the corresponding RAID configuration, HDD modules can
also be exchanged during operation.
10
85).
71).
Operating manual
Introduction
"Hot-
Econel 230R S1