Abc Codabar Dynamic Concatenation Timeout; Abc Codabar Force Concatenation - Datalogic PowerScan PD96 Series Product Reference Manual

ABC CODABAR

ABC Codabar Dynamic Concatenation Timeout

This parameter specifies the timeout in 10-millisecond ticks used by the ABC Codabar
Dynamic Concatenation Mode. The timeout can be set within a range of 05 to 255 in
10ms increments. A setting of zero specifies no delay.
Select ABC Codabar Dynamic Concatenation
Timeout Setting
$CCBDT
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.

ABC Codabar Force Concatenation

When ABC Codabar Concatenation is enabled and Force Concatenation is disabled, both
Codabar stand alone labels and ABC Codabar concatenated labels are transmitted.
When ABC Codabar Concatenation is enabled and Force Concatenation is enabled only
ABC Codabar concatenated labels are transmitted while Codabar stand alone labels are
not transmitted.
Force Concatenation has no effect if the ABC Codabar Concatenation is disabled. The
Force Concatenation mode has effect both in Static and Dynamic Concatenation Modes.
$CCBFC00
ABC Codabar Force Concatenation = Enable
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.

Timeout = 20 (200 msec)

ABC Codabar Force Contatenation = Disable
ENTER/EXIT PROGRAMMING MODE
Appendix D, Keypad represent-
CANCEL
$CCBFC01
PRODUCT REFERENCE GUIDE
175