Necessary Tools; A97 Installation - Ultraflex A97 Installation And Maintenance Manual

ULTRAFLEX
2 INSTALLATION

2.1 Necessary tools

10-14-16 mm hexagon wrenches
Cross slot screwdriver

2.2 A97 Installation

1 Install the cylinders on the external motors by carrying
out the instructions indicated in the manual.
NOTE
The operations described in point 3 PRE-ASSEMBLY
INSTALLATION can be carried out before installing the
cylinders on the engines.
2 BRACKET INSTALLATION A
With the Mercury Engines listed at page 8, it is necessary to assemble the bracket (1) on the central engine
arm by positioning the screws 5/16 UNF (2) and by putting the washers (3) between the bracket and the
screws. (All these elements are included in the bag E). Tighten to the torque indicated by the motor mechanic.
NOTE
Position the bracket with the spot-facing of the hole upwards and placed at the greatest distance from the
hole on the engine arm, as indicated in the figure.
Assemble the central bracket of the bar (A), position the longest screw included in the bag E (4) in line with the
hole of the just assembled bracket, and position one of the two screws included in the bag D (5) in line with the
hole of the engine arm, by putting the washers (6) (respectively included in the bag D and E) between them.
Installation and Maintenance Manual
2x
22 mm hexagon wrench
Loctite® 270
4
A
1
3
2
Dynamometric wrench
4mm hex key
5
6
page 9
-
TIE BAR A97
of 47