ULTRAFLEX
3 INSTALLATION
3.1 Necessary tools
3.2 Helm positioning
To install the helm on the boat, please refer to the assembly instructions supplied with ULTRAFLEX X34 -
X35 - X90 bezel kits.
3.3 Connection of the cable to the helm
1
Determine the correct entry position of the cable into the helm according to the proper steering
system.
2
R e m o v e
protective pipe
from
cable
ULTRAFLEX M90
Mach
and
insert the helix
cable into the
helm.
page 8
of 35 -
T93ZT STEERING SYSTEM
Phillips
screwdriver
PUSH OR PULL TURNING DIRECTIONS
3
Turn the steering wheel so as to "pull" the cable into the helm, aligning
the end fitting recess (A) with screw hole (1).
A
Installation and maintenance manual
Open end
wrench
10mm [0,39"]
T93ZT
1