Toshiba GR200 Series Instruction Manual page 733

Test operations
The user can change IED to for Test mode by the operations on the IED front panel with
Main/Sub menus, as shown in Figure 13.4-1.
Main Menu Sub-menu
Main Menu
Record
Monitoring
Setting
IO Setting
Control
Time
Test
Information
Security Setting
Login/Logout
Note: The structure and the contents about sub-menus depend on the hardware.
Test for communication
13.4.1
GOOSE sending block (GOSNDBLK)
(i)
This is used for selecting or disabling the GOOSE sending information where there is a conflict
in communication with another active IED while sending a GOOSE signal.
Sub-menu
Test Mode Test Option
Function Test
TestFlag-EN
Binary Input (Slot#n)
Binary Output (Slot#n)
Simultaneous Fault
Mode Change
MDCTRL-EN
MDCTRL-SELRST
MDCTRL-EXERST
Signal Monitoring
Term A
Term B
Term C
Figure 13.4-1 Structure of test menu
- 719 -
Sub-menu Sub-menu
S-TestFlagCancel
GOSNDBLK
GOSBUBLK
A.M.F.
Replica_CH1
Replica_CH2
Replica_CH3
Replica_CH4
Replica_CH5
Replica_CH6
Replica_CH7
Replica_CH8
Replica_CH9
Replica_CH10
Replica_CH24
BI*F OP
SLOT*-BI01-SET
SLOT*-BI02-SET
SLOT*-BI03-SET
.....
BO*F OP
SLOT*-BO01-SET
SLOT*-BO02-SET
SLOT*-BO03-SET
.....
6F2S1931 (0.20)
Sub-menu
CB-Test_CH1
DS11-Test_CH1
DS12-Test_CH1
DS13-Test_CH1
DS21-Test_CH1
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)