Toshiba GR200 Series Instruction Manual page 183

6F2S1931 (0.20)
Trip circuit (TRC)
When receiving the trip signals of respective protection functions, the trip circuit function
(TRC) is able to generate trip commands for CBs at every CH. The TRC function segments the
trip signals into three groups: General trip1, General trip2, and Transfer trip. The user can
connect the three-grouped trip signals with binary output circuits (BO†) so that the trips
command are delivered for every CB in respective CHs.
Technical description: Binary IO module
†Note: See Chapter (BIO) for more information.
─────────────────────────────────────────────────────────────────
Note: The implementation of particular features is dependent upon the selection of
hardware and the configuration of functions. Several IED models do not support certain
features. To determine whether a particular feature has been implemented within an IED,
identify the IED ordering number; and check the order number for the "G&T position" whilst
referring to the comparison table below. For more information, see Appendix: Ordering.
Table 2.7-1 Comparative table in respective ordering numbers
Ordering No. at "G&T"
Sec. Feature
30 31 32 33 34 Note
– TRC main features   
    
: Applicable NA: Not applicable

Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
- 169 -