Toshiba GR200 Series Instruction Manual page 275

Remove the receptacle from the header for changing to 1A.

When changing to 5A, insert the receptacle into the header.
The locations of the Jumpers are designated with the marks "W1" to "W14", which
are printed on the circuit board of the VCT. These "W*" marks, which are shown in Table
4.2-1, correspond to the Z* and CH* numbers.
Front
Tr.1
W1
W2
Tr.3 Tr.4
W3
W4
W5
Tr.5 Tr.6
W6
W7
W8
Tr.7
Tr.8
W9
W10
W11
Tr.9
W12
Tr.10
W13
W14
Tr.11
Tr.12
Layout of VCT components
Setting for 5 A rating
Figure 4.2-7 Jumpers and their locations
Rear
Tr.2
Tr.13 Tr.14
receptacle
header
- 261 -
VCT Photograph
Setting for 1 A rating
header
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
6F2S1931 (0.20)