Table of Contents
Advertisement
BOS1901-KIT
User Guide
Procedure
1. Select USB connection mode in the drop box.
2. Refresh the Port list using the button:
3. Select USB1 port in the Port drop box. (Note: If more than one development kit are connected on
the same PC the Port drop box will contains more than one entry. USB1 may not be the right
device.)
4. Click on Connect button.
5. Click on this icon
6. Enter the path to the firmware file (.hex) into the File Path text field.
7. Check the Verify programming checkbox.
8. Click on Start Programming button.
5
9. Wait the pop-up message indicating the upgrade completion.
BT001DDK04.01 – Issue 1
1
3
Figure 33: STM32CubeProgrammer connection setting
on the left side of the interface to open the Erase & Programming panel.
7
Figure 34: STM32CubeProgrammer programming setting
© All rights reserved 2021 Boréas Technologies Inc
4
2
6
8
50
Advertisement
Table of Contents
