Table of Contents
Advertisement
BOS1901-KIT
User Guide
11 FAQ and Troubleshooting
Please refer to Boréas website for FAQ and Troubleshooting information, which will be maintained
throughout the BOS1901-KIT lifecycle. It will also contain application note documents that will be
helpful for the user writing his/her own code to operate the BOS1901.
12 Notice and Warning
Danger High Voltage!
Electric shock possible when connecting board to live wire. Board should be handled with care by a
professional. For safety, use of isolated test equipment with overvoltage and/or overcurrent protection
is highly recommended.
This product uses semiconductors that can be damaged by electrostatic discharge (ESD). When
handling, care must be taken so that the devices are not damaged. Damage due to inappropriate
handling is not covered by the warranty.
The following precautions must be taken:
-
Do not open the protective conductive packaging until you have read the following and are at
an approved anti-static workstation.
-
Use a conductive wrist strap attached to a good earth ground.
-
If working on a prototyping board, use a soldering iron or station that is marked as ESD-safe.
-
Always disconnect the microcontroller from the prototyping board when it is being worked on.
-
Always discharge yourself by touching a grounded bare metal surface or approved anti-static
mat before picking up an ESD - sensitive electronic component.
-
Use an approved anti-static mat to cover your work surface.
Oscilloscope measurements:
Both OUT+ and OUT- are active outputs. When measuring these signals using an oscilloscope, use a
separate probe on each output. Never connect the ground of a probe to one of these outputs. Doing so
might damage the BOS1901-KIT and/or your oscilloscope. For more information, please consult the
Probing
BOS1901
with
https://www.boreas.ca/pages/support.
BT001DDK04.01 – Issue 1
an
Oscilloscope
application
© All rights reserved 2021 Boréas Technologies Inc
note
available
for
download
on
44
Advertisement
Table of Contents
