Removing And Installing The Clutch Pedal With The Over-Centre Helper Spring (Rapid) - Skoda Fabia II 2007 Workshop Manual

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
1.14 Removing and installing the clutch pedal
with the over-centre helper spring (Rap‐
id)
Note
Install the clutch pedal with a new bearing bolt.
Special tools and workshop equipment required
♦ Pliers - T10005-
♦ Allan key, wrench size 8 mm, commercially available
Removing
– Remove mounting bracket without master cylinder
⇒ page 44 .
– Remove the bearing bolt for the clutch pedal.
– Turn the bearing bolt for the clutch pedal to the left
-in direction of arrow-, for this purpose use the hexagon socket
wrench -1-, wrench size 8 mm.
While doing so, the catches -A- are destroyed.
Then the bolts -B- are positioned horizontally to the fitting position.
– Subsequently move the clutch pedal so that the bearing bolt
can be pulled out.
– Remove over-centre helper spring.
– Remove clutch pedal from bracket.
Install
• Install the clutch pedal with a new bearing bolt.
– Insert the over-centre helper spring laterally from the bottom
into the support -A- in the bracket next to the tappet of the
master cylinder and next to the clutch pedal.
• The area of the support -arrow- for the bearing bolt of the clutch
pedal must be vertical.
– Now position the over-centre helper spring on the centering
pin of the clutch pedal -arrow-.
48