Skoda Fabia II 2007 Workshop Manual page 164

Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02T - Edition 05.2014
♦ Interior extractor , e.g. -Kukko 21/7-
♦ Thrust plate - MP3-464 (30-205)-
♦ Dial gauge
The differential gear must be re-set when the following compo‐
nents are replaced:
♦ Gearbox housing
♦ Clutch housing
♦ Differential gear housing
or
♦ tapered-roller bearings of the differential gear.
On gearboxes made out of aluminium as of production date 12.06
the adjusting washer S 1 for outer ring/tapered-roller bearing is not
fitted
Bearing pedestal for outer ring/tapered-roller bearing is adapted.
– Measure the depth of the bearing pedestal for the outer ring/
tapered-roller bearing in the clutch housing.
Clearance "a"
Continued for all vehicles
– Press the outer ring/tapered-roller bearing (on the riveted pin‐
ion side of the differential housing) with adjusting washer S 1
(always 1mm thick) into the clutch housing made out of mag‐
nesium or without adjusting washer into the clutch housing
made out of aluminium.
Note
The inner and outer rings of the tapered-roller bearing are paired
- do not interchange.
– Press the outer ring/tapered-roller bearing (opposite side)
without adjusting washer into the clutch housing.
– Insert the differential gear housing together with the installed
inner rings/tapered-roller bearings into the gearbox housing.
– Position the clutch housing and tighten 5 screws to the given
tightening torque ⇒ page 116
160
Rep. gr.39 - Final drive - differential
15.2 mm
16.2 mm
.
Adjusting washer S 1
no
yes