Table of Contents
Advertisement
11
Attach the planetary gearbox carefully using appropriate attachment means,
e.g. lifting eye bolts, swivel hooks, shackles or a suitable equipment on an
appropriate lifting means, e.g. a crane hook. Refer to chapter 6.1 "Transporting
the MOBILEX GFT-W".
Carefully lift the planetary gearbox out of the cable drum.
12
13
Make sure that the surface is stable.
14
Place the disassembled planetary gearbox vertically with the cover plate down
on appropriate squared timbers on a stable underground.
15
Secure the planetary gearbox against tipping over.
16
Remove all means of attachment such as eye bolts, straps, chains, swivel
hooks, shackles or devices which are still attached.
17
Assemble the axial-piston motor to the planetary gearbox again. Proceed as
described in chapter 7, "Assembly".
12.4 Preparing the planetary gearbox for storage reuse
This chapter only describes how to prepare the planetary gearbox for storage
reuse.
For queries, please contact a Rexroth's subsidiary located near you or the main
plant directly. For the addresses of our national agencies, refer to
www.boschrexroth.com and the address directory in appendix A "Address
directory" of the material-number-specific operating instructions.
1
Carefully close all the openings of the planetary gearbox.
2
Clean the planetary gearbox as described in chapter 10.1 "Cleaning and Care".
3
Fill the planetary gearbox with lubricating oil for preservation according to the
selection list – industrial gear oils in appendix B "Required and supplementary
documentations" in the material number-specific operating instructions. Fill the
planetary gearbox as described in chapter 8.1.3 "Filling the planetary gearbox
with lubricating oil" in these operating instructions.
4
Preserve the surfaces of external flanges, shaft ends and flange surfaces with a
preservative (e.g. PERIGOL VCI 230 or CUSTOS 10-38). Observe chapter 6.2.1
"Preservation" and the associated product data sheets and safety data sheets.
5
Store the planetary gearbox as described in chapter 6 "Transport and storage".
RE 79100-01-B/11.2020, MOBILEX GFT-W general operating instructions series 30, Bosch Rexroth AG
Disassembly and replacement
79/86
Advertisement
Table of Contents
