Table of Contents
Advertisement
General information concerning damage to property and product damages
Damage to the planetary gearbox caused by commissioning without or with
insufficient lubricating oil!
When commissioning the planetary gearbox and the integrated static multiple-
disk parking brake without, or with insufficient lubricating oil can damage or even
being completely destroyed!
When commissioning or recommissioning the crane or winch application, fill
the planetary gearbox with the correct quantity of oil.
Control the oil level thoroughly.
Pay attention when commissioning the crane or winch application, that the
housing chamber and the axial-piston motor (if included in the scope of
supply) service lines are filled with hydraulic fluid and remain filled during
operation.
Always replace the disks, springs and sealing elements after any malfunction,
thermal overload and during any repair work on the multiple-disk parking
brake.
Damage to the planetary gearbox caused by commissioning with too much
lubricating oil!
When commissioning the planetary gearbox and the static multiple-disk parking
brake, integrated in the planetary gearbox, with too much lubricating oil, thermal
overloads may occur, causing damage to the gears, seals and bearings as well as
failure of the static multiple-disk brake!
When commissioning or recommissioning the crane or winch application, fill
the planetary gearbox with the correct quantity of oil.
Control the oil level thoroughly.
Always replace the disks, springs and sealing elements after any malfunction,
thermal overload and during any repair work on the multiple-disk parking
brake.
Damage caused by penetrating liquids, foreign objects and dirty lubricating oil!
Wear and malfunctions caused by impurities!
Check whether all seals, connections and plug-in connectors have been
correctly installed and are intact.
When performing any work on the planetary gearbox, please ensure extreme
cleanness to prevent foreign objects, as for example weld spatter or metal
particles, from getting into the planetary gearbox and, therefore, causing wear
and malfunction.
Only use clean connections.
Exclusively install clean hydraulic lines.
No dirt shall penetrate when closing the ports.
RE 79100-01-B/11.2020, MOBILEX GFT-W general operating instructions series 30, Bosch Rexroth AG
NOTE
17/86
Advertisement
Table of Contents
