Table of Contents
Advertisement
256/407
Notes on project planning
Gearbox attachment
Coupling attachment
Bevel gear pinions or skew bevel driving pinions
Bosch Rexroth AG R911335703_Edition 04
The machine design and the attachment elements used have to be carefully
adapted to the motor type so that the load limits of shaft and bearing are not
exceeded.
When gearboxes are attached to motors, this changes the thermal
connection of the motor to the machine or installation design.
According to the gearbox type, the heat generation at the gearbox is
different. In any case, gearbox attachment reduces the heat dissipation of the
motor via the flange. This has to be taken into account when doing the
project planning for the installation.
To avoid thermal overload of motors when using gearboxes, it is necessary to
reduce the specified performance data.
Fig. 7-30:
Qualitative change in the S1 characteristic in the case of gearbox at‐
tachment
The torques specified in the motor characteristics have to be
reduced by approx. 10–20% when gearboxes are attached.
Observe all other notes and requirements contained in the documentations
on the gearboxes used.
The machine design and the attachment elements used have to be carefully
adapted to the motor type so that the load limits of shaft and bearing are not
exceeded.
NOTICE
When connecting extremely stiff couplings, the radial force which constantly
changes the angular position may cause an impermissibly high load on the
shaft and bearing.
Owing to thermal effects, the flange-side end of the output shaft may offset
by up to 0.6 mm in relation to the motor housing. If helical driving pinions or
bevel gear pinions directly attached to the output shaft are used, this change
in position will lead to
IndraDrive Mi Drive Systems with KCU02, KSM02,
KMS02/03, KMV03, KNK03, KLC03
Risk of damage!
Advertisement
Table of Contents
