Keyspan USB Server Version 1.3.1 User Manual page 51

next light.
SYSTEM Status Lights: 2 and 3
Look at the USB status lights 2 and 3 (the two red lights under under SYSTEM. Status 2 is the red
light in the middle and Status 3 is the rightmost red light). Please note the status of Status 2 and 3.
If:
• System 2 is On / System 3 is On: The server has obtained an IP address via DHCP (ie your
DSL router) and does not show any users connected to the USB Server. If your computer
is turned on, proceed to the Troubleshooting:UDP Ports sub section.
• System 2 is On / System 3 is Off: The server is configured to use a Static IP (ie you've
configured the USB Server's settings prior to troubleshooting) and does not show any
users connected to the USB Server. If your computer is turned on, proceed to the
Troubleshooting:UDP Ports sub section.
• System 2 is Off / System 3 is On: The server obtained an IP address via Zeroconfig (ie you
don't have a DSL router and you have not specified IP settings) and does not show any
users connected to the USB Server. If your computer is turned on, proceed to the
Troubleshooting:UDP Ports sub section.
• Status 2 is Off / Status 3 is Off: This is normal and indicates the USB Server hardware is
working. More specifically, the USB Server has obtained a IP address and has detected
users (client computers) connected to it. Skip ahead to the Troubleshooting: USB Devices
sub section.
Troubleshooting:UDP Ports
Make sure that your Keyspan Server Utility software and hardware are communicating on the same
UDP port. To verify this, open the Keyspan Server Utility application. You USB Server should
appear (see next image):
In the Keyspan Server Utility application's Servers tab, is your USB Server listed? If your server:
• Is Not Listed: The Keyspan Server Utility software cannot find the USB Server hardware.
Change the Keyspan Server Utility software's Local UDP Port (use the LOCAL
SETTINGS tab's UDP Port field) to match the UDP port that is being used by the USB
Server hardware. If you do not know the UDP port that your server software is using, try
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
Page 51