2 Installation Instructions
Installing the USB Server Hardware
Note: Do not connect your USB device(s) to the Keyspan USB
Server until you have finished installing the USB Server
software and hardware!!! The next section, Using Your USB
Devices Over Your Network, will walk you through the process of
connecting and using your USB devices with the Keyspan USB Server.
Step 1
-
Connect The Keyspan USB Server To Your Network
First connect an Ethernet cable to the USB Server's Ethernet port (see next image):
Once the Ethernet cable is connected, connect the other end of the cable to your network. This can
be a free Ethernet port on your DSL router, Ethernet hub, or 802.11 (aka Airport) router/base
station.
If you do not have a network, you can connect the USB Server directly to the Ethernet port on your
computer.
Tech Note: If you have more questions about connecting the USB Server to your
network, please read the USB Server Networking Discussion section in this
manual.
Step 2
-
Connect the USB Server's Power Supply / Read the LEDs
Connect the included power supply to the USB Server's power connector (see next image):
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
Page 3