Table of Contents
Advertisement
the extra printers in the Printers and Faxes window or enable Auto-Connect for all
of the 'printers'.
Step 3
- Using Your Printer Via Auto-Connect
Now that you have setup your printer via Auto-Connect, you're ready to print. There is nothing
special you need to do. Just print your documents as you would normally. Depending on your
printer, you may get a warning stating that your printer is disconnected. IGNORE THESE
WARNINGS as the Auto-Connect feature will connect the printer for you. Once the printer gets
'Auto-Connected', your print job will be sent to the printer (this may take a few seconds).
When the printer has finished printing, Auto-Connect will disconnect your printer and make it
available to other users.
About Multiple Print Jobs From Multiple Users
If you have 2 users printing to the same printer, Auto-Connect will connect the whichever computer
reaches the USB Server first. The second user's print job will stay in the queue until the first user
finishes printing. Once the first user's print job is finished, the first user will be disconnected and
the second user will connect to the printer and his print job will automatically start.
Using The USB Server System Tray Feature
The USB Server system tray icon allows you to quickly:
• open the Keyspan Server Utility
• configure Auto-Connect settings
• connect and disconnect to USB devices on your USB Server
MACINTOSH NOTE:
The USB Server System Tray is currently Windows only but a Mac OS X version of this
feature is currently in development. Please contact Keyspan for details.
To do any of the above, first find the Keyspan USB Server System Tray icon. The System Tray is
located in the lower right hand corner of your screen (next to the time).
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
Page 15
Advertisement
Table of Contents
