When You Need More Help - Keyspan US-4A User Manual

Reset Using The Reset Button
To reset your hardware, please make sure that you have:
a straightened or unfolded paper clip or a (similar object without a sharp tip)
your USB Server is turned on
Next, locate the reset hole. This is located on the top of your USB Server (see next image):
Using your paper clip, quickly press the reset button inside the hole. This will reset/reboot your
server.
Reboot Server Into 'Temporary Default Settings Mode' Using The Reset Button
If you've made an unwanted change to the USB Server settings and can't access your server
anymore, you can boot your server into a 'Temporary Default Settings Mode'. In this mode, your
server will reboot using default settings (ie Multi-user connect mode, default IP mode) and allow
you to view and edit your server's settings. If you want to return to your settings, just power cycle
your server.
To boot into 'Temporary Default Settings Mode', press and hold the reset button until the lights turn
off (this will take 3+ seconds).
The USB Server is now resetting itself. It will take approximately 15 seconds to complete the reset.
In the Keyspan Server Utility application, make sure that your Local UDP Port is set to 3842.
Once you've verified the port, check the the Keyspan Server Utility application to see if your server
appears. If it does not appear, please contact Keyspan technical support for further assistance.

When You Need More Help...

The Keyspan web site, http://www.keyspan.com/ is your best source for technical support
information. The web site includes technical notes, reference manual updates, and answers to
frequently asked questions.
You may also contact our technical support department directly via email, phone, or fax. Please see
the Support Information section in this manual for more details.
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
Page 55