Keyspan US-4A User Manual page 23

Status: This is the current Status of your USB Server's hardware and software. This
column will show if the Keyspan Server Utility software has successfully
communicated with your USB Server hardware. For details, please see the
Server Status Details subsection later in this manual.
Server Status Details
The Server Status are:
Old Firmware:
Temp. Defaults:
Login Failed:
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
OK: The Keyspan Server Utility software has successfully found the USB
Server hardware. You can now communicate with the selected USB
Server. Note: The USB Server may have an Client Access
Password or a Configuration Password that would prevent from
users from using that specific server or changing the selected server's
configuration. For more information about these passwords, please
please see the USB Server Settings : Access Tab subsection later in
this manual.
The USB Server hardware contains 'old' firmware. This happens your
computer has newer software than the firmware on the USB Server
hardware. If you see this message, you must upgrade your USB
Server's firmware. To do this, select your USB Server in the Servers
tab and click the Edit Server Config button. For more details, please
read the Updating Your USB Server's Firmware subsection later in
this manual.
The USB Server hardware has been put into Temporary Default
Settings Mode. This mode allows you to temporarily return the USB
Server to it's factory settings for diagnostics. You can edit your
previous setting while you are in the Temporary Default Settings
Mode. For more information about how to set your USB Server into
Temporary Default Settings Mode, please please see the Reboot
Server Into 'Temporary Default Settings Mode' Using The Reset
Button subsection (in the Troubleshooting section) later in this
manual.
The USB Server could not connect to the selected USB Server because
the USB Server has a password. You computer either does not have a
password set in the Server Access Settings field in the Local
Settings tab or you have entered an incorrect password for your USB
Server. For more information about these passwords, please please
see the USB Server Settings : Access Tab subsection later in this
manual. mismatch server discovery information.
Page 23