Keyspan US-4A User Manual page 40

When you are finished entering your Personal Communication settings, click the Apply button
to save your changes. Click the Cancel button to cancel your changes. Click the Restore
Defaults button to restore the default Personal Communication Settings values.
Server Access Settings
The Server Access Settings in the Local Settings tab, is used when you want to connect to a
USB Server that has been either password protected or has been setup to use Active Discovery.
For most users, Server Access Settings will be blank and not contain any settings. If you need to
access a USB Server that has been either password protected or is using Active Discovery, click
the Add button as shown below:
This will open the Configure Server Access window:
Server Server Number: This is the serial number of the USB Server that you want to connect to.
Access Password:
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
broadcast on a different address, you will need to change the address
here.
You only need to enter the last five digits.
Enter the USB Server's password here.
Page 40