Keyspan US-4A User Manual page 24

Attempting Discovery:
Attempting to Connect:
Editing Your USB Server's Settings
To edit a specific server's setting, select it from the list and click the Edit Server Config button
(see next image):
This will open the the Edit Server Configuration window (see next image). This window has three
tabs, Access, Network, and Device Configuration. For details about these tabs and what settings
can be configured, please read the USB Server Settings : Access Tab, USB Server Settings :
Network Tab, and USB Server Settings : Device Configuration subsections later in this
document.
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
The Keyspan Server Utility software is attempting to locate USB
Server hardware on your networks. This message will temporarily
appear when you first start up your computer or when you reboot the
USB Server. Attempting Discovery also means that the client software
is attempting to make a connection to the server over WAN/Internet. If
this message does not go away, please read the Troubleshooting
section later in this manual.
The USB Server hardware is sending 'Broadcast' messages to your
computer but the connection to the USB Server hardware cannot be
made. If you have modified your USB Server's settings, set the USB
Server to the Temporary Default Settings Mode and change your
settings. If this message does not go away, please read the
Troubleshooting section later in this manual.
Page 24