Updating Your Usb Server's Firmware - Keyspan US-4A User Manual

Restoring the default settings will cause the USB Server (hardware) to restart.
Tech Note: Restoring to default settings will also set the USB Server's UDP port to
3842 and the Multicast address to 239.255.176.42. If you previously changed your
UDP port and/or Multicast address, remember to change the Keyspan Server Utility
application's Local UDP Port to 3842 and Multicast address to 239.255.176.42. You
may not be able to see your USB Server if you fail to change your Local UDP Port a
nd/or Multicast address. To change the Local UDP Port, go to the Local Settings
tab and edit the UDP Port field.
IMPORTANT NOTE FOR FIREWALL USERS: If you've configured your firewall
to allow access to the USB Server, remember to check your firewall's setting. The USB
Server's IP address may have changed after restoring to default settings.

Updating Your USB Server's Firmware

The Keyspan USB Server's firmware can be updated at any time via the Keyspan Server Utility
application.
To do this, select the Servers tab, select your USB Server, and then click the Edit Server Config.
If your USB Server requires new firmware, you will receive a pop-up window with instructions on
how to update the server's firmware.
To manually update your server's firmware, select the Servers tab, select your USB Server, and then
This User Manual applies to the Keyspan USB Server Software Version 1.3.x. Patent Pending.
Rev 2005jun23
Keyspan:USB Server - User Manual
Page 36