Table of Contents
Advertisement
EQ-IO Interface Unit
•
The hardware consists of the EQ-IO interface unit (A-5923-0110, A-5923-0100) .
•
A-5923-0110 is EZ-IO licensed and A-5923-0100 is unlicensed . The secondary, unlicensed unit
is used to extend the number of lines available, see detailed information in the 'Using two EQ-IO
interface units' section .
•
A 3 m USB type A to USB type B cable is supplied to connect the EQ-IO interface unit to the Equator
Controller. Maximum length of the USB cable, as defined by the USB 2.0 specification, is 5 m.
NOTE: It is strongly advised that USB signal repeaters are avoided, as they can suffer from interference .
CAUTION: The EQ-IO – Interface unit requires one of the following versions of the Equator Software Suite:
Equator Software Suite version 1 .5 .6 with 1 .5 .6 .3 patch applied
Equator Software Suite version 1 .5 .7 or later
NOTE: For Equator Software Suite versions pre 1 .5 .6, please contact your local Renishaw representative
A-5923-0110 (EZ-IO licensed)
8
EQ-IO - Interface unit user guide
V .4
V .4
A-5923-0100 (Unlicensed)
V .4
Advertisement
Table of Contents
