Output Stage - Renishaw EQUATOR EQ-IQ User Manual

Output stage

• The EQ-IO output stage has volt-free, relay style, normally open contacts with internal pull-up
resistors connected to the OUTPULL pin .
Output Characteristics
Output absolute maximum voltage (after which damage will occur)
Maximum output current
Internal pull resistor between OUTx and OUTPULL
OUTPULL voltage*
*Measured to OUTCOM .
• If a +3 .3 V to +24 V logic input stage is used by the connected PLC/machine, the 0 V (ground) and
signals should be wired directly to the receiving interface as shown .
• The output stage may also be used to switch loads such as relays or LED indicators as shown .
Min Typical Max
- - 30
- - 100
- - 10
- - 100
www.renishaw.com
Unit
V
mA
kOhms
mA
11