Table of Contents
Advertisement
Using two EQ-IO interface units
•
A secondary, unlicensed, EQ-IO interface unit (A-5923-0100), may be used to facilitate additional lines
for DMIS Part Program selection . Each EQ-IO interface unit must be connected to an individual USB
port . USB ports available on the Equator Controller are shown below .
THE EQ-IO – INTERFACE UNIT (VERSION 4 OR LATER) REQUIRES ONE OF THE FOLLOWING
VERSIONS OF THE EQUATOR SOFTWARE SUITE:
Equator Software Suite version 1 .5 .6 with 1 .5 .6 .3 patch applied
Equator Software Suite version 1 .5 .7 or later
For Equator Software Suite versions pre 1 .5 .6, please contact your local Renishaw representative .
The Equator Software Suite version can be found in the settings screen . To open the settings screen, click
on the settings button in the toolbar .
14
EQ-IO - Interface unit user guide
Connection to Equator Controller - USB ports
USB ports for
keyboard and
mouse
USB ports for
EQ-IO
Equator Controller
Version 06
Equator Controller
Versions 07 & 08
Advertisement
Table of Contents
