Table of Contents
Advertisement
User's Manual
２-２. List
The List tab is used to show which dynamixel is connected to the USB2Dynamixel.
The following picture shows that there are a total of three dynamixels connected.
Specifically, two dynamixels with the B
aud rate 1 are connected, and their IDs are
No. 1 and 4. A dynamixel with the Baud rate 34 is connected, and its ID is No. 2.
Only one dynamixel can be dr
iven. To drive it, click on the corresponding ID.
When a communication error breaks out between the USB2Dynamixel and the
dynamixel, click on the dynamixel in question, then the following error message
appears. If the OK button is pressed, the dynamixel where the communication
error broke out will disappear from the list.
16
Advertisement
Table of Contents
Need help?
Do you have a question about the USB2Dynamixel and is the answer not in the manual?