NETGEAR WAX214 User Manual page 55

NETGEAR WiFi 6 AX1800/AX3600 Dual Band PoE/PoE+ Access Points, WAX214 and WAX218
7. In the Wireless Setting - Access Point 2.4GHz/5GHz section, specify the radio band,
SSID name, and isolation security settings, as described in the following table.
Setting
Enable
SSID
Hidden SSID
Client Isolation
VLAN Isolation
L2 Isolation
8. In the Wireless Security section, specify WiFi enterprise security by selecting an
option from the Security Mode menu, as described in the following table.
Manage the Basic Radio and
WiFi Settings
Description
To enable the SSID to broadcast on both the 2.4 GHz radio and the 5 GHz radio,
select the 2.4G and 5G check boxes. If you clear a check box, the SSID is not broadcast
on the radio.
The SSID is the WiFi network name. Specify a name for the SSID with a maximum of
32 characters. You can use a combination of alphanumeric and special characters,
except for quotation marks (") and a backslash (\).
To hide the WiFi network name and prevent it from displaying in the scanning list of
a WiFi client, select the Enable radio button. To connect to the WiFi network, a user
must know the WiFi network name. By default, this option is disabled.
To prevent WiFi clients that are associated with the same or different WiFi networks
on the access point from communicating with each other, select the Enable radio
button. By default, this option is disabled. If you enable client isolation, WiFi clients
can still communicate with each other over the Internet.
Note: If L2 isolation is enabled, the Client Isolation radio buttons are disabled.
To prevent clients on different VLANs from communicating with each other, select
the Enable radio button, and enter the VLAN ID in the ID field. By default, this option
is disabled.
For the first SSID, the default VLAN ID is 1, for the second SSID, the default VLAN ID
2, for the third SSID, the VLAN ID is 3, and for the fourth SSID, the VLAN ID is 4. The
range is from 1 to 4094. If you enable VLAN isolation, clients can still communicate
with each other over the Internet.
To prevent WiFi and LAN clients on the same access point from communicating with
each other, select the Enable radio button. By default, this option is disabled. If you
enable L2 isolation, clients can still communicate with each other over the Internet.
If you enable L2 isolation, to exclude a device from L2 isolation, enter the MAC address
of the device in a Whitelist field. You can exclude up to three devices.
55 User Manual