Overheating Protection - Miele ProLine CS 1212-1 Operating And Installation Instructions

Overheating protection

All the induction coils and heat sinks for
the electronic module are fitted with an
overheating protection mechanism. Be-
fore the induction coils or heat sinks get
too hot, the overheating protection
mechanism intervenes in one of the fol-
lowing ways:
Induction coils
- Any Booster function in operation will
be switched off.
- The set power level will be reduced.
- The cooking zone turns off automat-
ically.  will appear in the cooking
zone display.
- Other cooking zones switch off auto-
matically.
Heat sinks
- Any Booster function in operation will
be switched off.
- The set power level will be reduced.
- The cooking zones switch off auto-
matically.
The affected cooking zones can only be
used again as usual once the cooling
element has cooled down to a safe
level.
 Switch the relevant cooking zone(s)
off.
If the cooking zone is not switched off,
 flashes alternately with  in the relev-
ant cooking zone display.
You can use the cooking zone again as
usual when the fault message has gone
out.
The overheating protection may be ac-
tivated under the following circum-
stances:
- The cookware being heated is empty.
- Fat or oil is being heated on a high
power level.
- There is insufficient ventilation to the
underside of the hob.
- A hot cooking zone is switched back
on after an interruption to the power
supply.
If, despite removing the cause, the
overheating protection mechanism trig-
gers again, contact customer service.
Safety features
33