Use Of The Reducer For Infants - Chicco OneSeat Manual

the 90° position while travelling, this
position is only meant for putting the
child in the seat before travel and re-
moving the child after travel.
WARNING! The only reclining posi-
tion permitted in the rear-facing con-
figuration is position No. 1.
WARNING! Check the car seat har-
nesses for proper tension, leaving at
least one finger width of "wiggle room"
between the child's shoulder and the
harness.
8. USE OF THE REDUCER FOR
INFANTS
The car seat is equipped with a boost-
er cushion composed of: seat, lateral
inserts, pad and headrest.
The complete booster cushion, with
all the components, must be used
from birth to 8 kg.
The booster cushion can be used
without the pad, lateral inserts and
headrest from 9 kg to 12 kg.
WARNING! The booster can only be
used in the rear-facing position.
0-8 KG
FACING AWAY
FROM THE DIREC-
TION OF TRAVEL
9-12 KG
FACING AWAY
FROM THE DIREC-
TION OF TRAVEL
(fig. 12).
9. USING THE CAR SEAT IN THE
FORWARD-FACING
The car seat can be fit front-facing in
the Group 1 configuration (9-18 kg),
ALWAYS using the Isofix connectors
and support leg.
• Installing the car seat on the seat of
• Rotate the seat of the car seat using
PLACING THE CHILD IN THE SEAT:
• Press the belt adjustment button (K)
• Unbuckle the car seat belts by press-
• Hook the two buckle tongues of the
• Place the baby in the car seat with
• To adjust belt tightness, pull the ad-
• Return the car seat to the forward-fac-
POSITION: WARNING! NEVER use the car seat in
33
Gr. 1 (9-18 kg) / ca. 1-4 years
the vehicle with Isofix and support
leg (see paragraph 5. ISOFIX AND
SUPPORT LEG INSTALLATION).
the lever (N) until it is positioned at
90°, facing the parent, to facilitate
placing the child in the car seat (Fig.
9.4).
and hold and pull both the car seat
harnesses toward yourself until the
maximum length is reached (Fig.
11.1).
ing the red button on the buckle (Fig.
11.2).
belt to the sides of the car seat to facil-
itate placing the child in the seat (Fig.
11.3).
care, join the two buckle tongues
and fasten them in the buckle again
(Fig. 11.4).
justment strap (L) upwards with cau-
tion until the belt is suitably tight (Fig.
11.5).
ing direction and check that the seat
has locked in place (the indicator (O)
must be green) (Fig. 9.3).