Chicco OneSeat Manual page 32

that permits 360° rotation by oper-
ating the lever (N) (Fig. 9.1) to easily
switch from the rear-facing position
(Fig. 9.2) to the forward-facing position
(9.3). When travelling the car seat must
be locked in either the rear-facing or
forward-facing position and seat rota-
tion indicator (O) must be green.
Rotating the seat by 90° to face the
parent (Fig. 9.4) can be helpful when
removing the child from the car seat,
but it is not a travel position, and the
indicator (O) will therefore remain red.
WARNING! NEVER use the car seat in
the 90° position while travelling, this
position is only meant for putting the
child in the seat before travel and re-
moving the child after travel.
7. USING THE CAR SEAT IN THE
REAR-FACING POSITION: Gr. 0+
(0-13 kg) and Gr. 1 (9-18 kg) / 0-4
years
When using the car seat in the Group
0+ (0-13 kg) configuration, it must
ALWAYS be installed in the rear-facing
position using the Isofix connectors
and the support leg.
For the Group 1 (from 9 kg and up to
18 kg) configuration, installation in the
rear-facing position is optional but
strongly ADVISED to provide greater
safety for the child.
• Installing the car seat on the seat of
the vehicle with Isofix and support
leg (see paragraph 5. ISOFIX AND
SUPPORT LEG INSTALLATION).
• Check the presence of the reducer
on the basis of the instructions for
use (see paragraph 8. USE OF THE
REDUCER FOR INFANTS).
• Position the car seat in the for-
ward-facing position and act on the
reclining lever (M) to recline the car
seat fully until position 4 is reached
(Fig. 10) then rotate into the rear-fac-
ing position (Fig. 9.2) making sure
that the car seat is reclined in posi-
tion 1.
• Rotate the seat of the car seat using
the lever (N) until it is positioned at
90°, facing the parent, to facilitate
placing the child in the car seat. (fig.
9.4).
PLACING THE CHILD IN THE SEAT:
• Press the belt adjustment button (K)
and hold and pull both the car seat
harnesses toward yourself until the
maximum length is reached (Fig.
11.1).
• Unbuckle the car seat belts by press-
ing the red button on the buckle (Fig.
11.2).
• Hook the two buckle tongues of the
belt to the sides of the car seat to facil-
itate placing the child in the seat (Fig.
11.3).
• Place the baby in the car seat with
care, join the two buckle tongues
and fasten them in the buckle again
(Fig. 11.4).
• To adjust belt tightness, pull the ad-
justment strap (L) upwards with cau-
tion until the belt is suitably tight (Fig.
11.5).
• Rotate the car seat into the rear-fac-
ing position making sure that the
seat is locked in place (the indicator
(O) must be green) (Fig. 9.2) and that
the car seat is in position No. 1.
WARNING! NEVER use the car seat in
32