Wiring Procedures For The One-Touch Connector - Mitsubishi Electric AJ65VBTCU-68DAVN User Manual

4 SETUP AND PREPARATION BEFORE OPERATION

4.10.2 Wiring procedures for the one-touch connector

Plug body
4 3 2 1
Metal contacts
(To the next page)
4 - 18
The following are the wiring procedures for the one-touch connector.
Plug cover
Metal contact
V+
COM
1) Check the connector.
Check that the plug cover is attached to the plug body.
Note: Do not push the plug cover into the plug body.
Once pressed, the plug cannot be used any more.
2) Processing for analog output cable
Strip the cable 3cm or more, cut the outer sheath and then the
shielded wires to the proper length.
If the electric wire lengths are not even, trim their ends with a
nipper to the same length so as to insert them neatly into a
connector.
3) Insert the cable.
Lift the end of the plug cover and insert the cable until it almost
reaches the plug body (within 1mm from the other end of the
plug cover).
Insufficient cable insertion may cause improper press fitting.
Note: When inserting the cable, prevent the cable from sticking
out from the plug cover end.
MELSEC-A
4 - 18