Table of Contents
Advertisement
4 SETUP AND PREPARATION BEFORE OPERATION
4 - 9
POINT
(1) Set the offset and gain values in the actual usage state.
(2) The offset and gain values are stored on E
and are not cleared at power-off.
(3) Make offset/gain setting within the range indicated in POINT of Section 3.3.1
and Section 3.3.2. If setting is made outside this range, the maximum
resolution/accuracy may not fall within the performance specifications range.
(4) When making offset/gain setting (in the test mode), set any of the following test
modes with the mode select switch.
AJ65VBTCU-68DAVN (Ver. 1 remote device station): 1, 2
AJ65VBTCU-68DAVN (Ver. 2 remote device station): 4, 5
The user range settings 1 selected with the mode select switch set to 1 and 4
are the same. The setting of the user range setting 1 can be changed by setting
the mode select switch to either 1 or 4. This also applies to the user range
settings 2 selected with the mode select switch set to 2 and 5.
If the switch has been set to any unusable number, an error occurs and the
"RUN" LED flickers at intervals of 0.1s.
MELSEC-A
2
PROM in the AJ65VBTCU-68DAVN
4 - 9
Advertisement
Table of Contents
Troubleshooting
