Table of Contents
Advertisement
GBA Z 0898 0 E
3.6
C
ONTROL
3.6.1
T
URN UNIT ON
Click knob and turn to select power level.
3.6.2
LED R
ING
The LED ring flashes if operator input is
needed.
The LED ring lights up continuously during
cooking or holding.
3.6.3
S
WITCHING BETWEEN COOKING AND
HOLDING MODE
1. During operation, click knob once. The LED
flashes.
2. While watching the display, turn knob clock-
wise or counter-clockwise to activate Power
Level Mode or Hold-Mode.
3. Click knob again to confirm selection.
3.6.4
S
ETTING POWER LEVEL
/
AND LOCK
UNLOCK
1. In Power Level Mode, turn knob clockwise to
choose power level:
Power level (1) = lowest power
Power level (12) = highest power
2. To lock power at set level, press down knob
until the word "LOCK" on the display lights
up. This takes 2 seconds.
3. To unlock, press down knob again until the
word "LOCK" on the display goes dark. This
takes 2 seconds.
BA
Last revised 05-2019
(1
12)
TO
Page 28 of 39
Power level settings
The power diagrams (below) show that the dif-
ference in power output between two higher
power levels is much larger than that between
two lower power levels.
This power level and output relationship gives
you a fine simmer-rate control in the low power
range, and an instant response in the high power
range.
POWER DIAGRAM 1: POWER LEVEL 0 TO 12
The settings from (1) to (9) span the lower
50% of the total power output; the settings
from (10) to (12) cover the 50% to 100% out-
put range.
3.6.5
S
ELECTING HOLD TEMPERATURE
/
AND LOCK
UNLOCK
1. In Hold-Mode, turn knob until the desired
temperature is shown on the display.
2. Leave the knob for approximate 5 seconds,
the display will show the actual detected
temperature.
3. To lock temperature at set level, press down
knob until the word "LOCK" on the display
lights up. This takes 2 seconds.
4. To unlock, press down knob again until the
word "LOCK" on the display goes dark. This
takes 2 seconds.
Mai 3, 2019
Rev. 0
Advertisement
Table of Contents
Troubleshooting
