Connecting To The Hpe Synergy Console Using A Laptop Computer - HP HPE Synergy 12000 Frame Setup And Installation Manual

Connecting to the HPE Connecting to the HPE Synergy Console
WARNING: WARNING:
Do not plug the front panel laptop port into a switch. The front panel laptop port is designed to
provide a single laptop access to the HPE Synergy Console. Plugging the laptop port into a
switch may cause issues on a network where DHCP is running.
Prerequisites Prerequisites
At least one frame link module is installed in one of the frame link module bays.
Procedure Procedure
1. Ensure that the Ethernet port of the laptop computer is configured for DHCP.
Alternatively, you can configure the laptop computer Ethernet port to the IP address: 192.168.10.2 with the subnet mask
255.255.255.0.
2. Use a CAT5 cable to connect the laptop computer Ethernet port to the laptop port on a front panel module.
3. Wait for the laptop computer to be assigned an IP address from the frame link module.
4. Access the HPE Synergy Console using either a VNC client or web browser:
Web browser: Open a web browser and enter Web browser:
http://192.168.10.1
.
Alternatively, you can include the legacy port number.
http://192.168.10.1:5800
VNC client: Open a VNC client and connect to VNC client:
192.168.10.1
port
5900
.
A VNC client will load to the web browser and open the HPE Synergy Console.
Synergy Console using a laptop computer using a laptop computer

Connecting to the HPE Synergy Console using a laptop computer

125