Installing The Switch Holders ∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙∙102; Installing The Switch Holders - Vatech Pax-i PCH-2500 Installation Manual

6 Completing Miscellaneous Works

6.5 Installing the Switch Holders

Item
SWITCH HOLDER
(Exposure switch)
SWITCH HOLDER
(Up/Down switch: Optional)
UP/DOWN switch holder
1. Peel off the paper from both sides.
Exposure switch holder
1. Locate the exposure switch holder (Part No.12) with a sticker and 3 screws.
2. Install the switch holder on the wall at the appropriate height using 3 screws.
Attaching the UP/DOWN switch (Optional)
View from the bottom of the handle frame
102
Part No. Figure
12
13
2. Attach the UP/DOWN switch holder on the left
If the Up/Down switch (Part No.3) is to be
installed, connect it to the following connector.
Qty
1
1
side of the column at the appropriate position.
PaX-i (PCH-2500) Installation Manual
Comment
w/sticker and 3
screws
w/sticker