Dell EMC Edge 3200 User Manual page 45

Figure 49. Console Redirection COM1 Settings
Table 31. Console Redirection COM1 Settings
Parameter Settings
Terminal Type VT100, VT100+, VT-UTF8,
ANSI
Bits per second 9600, 19200, 38400,
57600, 115200
Data Bits 7, 8
Parity None, Even, Odd, Mark,
Space
Stop Bits 1, 2
Flow Control None, Hardware RTS/CTS Flow control can prevent data loss from buffer overflow. When sending
VT-UTF8 Combo Key Disabled, Enabled
Support
Recorder Mode Disabled, Enabled
Resolution 100x31 Disabled, Enabled
Putty KeyPad VT100, LINUX, XTERMR6,
SCO, ESCN, VT400
Description
Emulation: ANSI: Extended ASCII char set. VT100: ASCII char set.
VT100+: Extends VT100 to support color, function keys, and so on. VT-
UTF8: Uses UTF8 encoding to map Unicode chars onto 1 or more bytes.
Selects serial port transmission speed. The speed must be matched on
the other side. Long or noisy lines may require lower speeds.
Data bits
A parity bit can be sent with the data bits to detect some transmission
errors. Even: parity bit is 0 if the num of 1s in the data bits is even. Odd:
parity bit is 0 if num of 1s in the data bits is odd. Mark: parity bit is always
1. Space: Parity bit is always 0. Mark and space parity do not.
Stop bits indicate the end of a serial data packet. (A start bit indicates the
beginning). The standard setting is 1 stop bit. Communication with slow
devices may require more than 1 stop bit.
data, if the receiving buffers are full, a stop signal can be sent to stop
the data flow. Once the buffers are empty, a start signal can be sent to
restart the flow. Hardware flow control uses two wires to send start and
stop.
Enable VT-UTF8 combination key support for ANSI/VT100 terminals.
With this mode enabled, only text is sent. This is to capture terminal data.
Enables or disables extended terminal resolution.
Select FunctionKey and KeyPad on Putty.
BIOS Setup 45