Table of Contents
Advertisement
T O R Q U E S E T T I N G S F O R S C R E W S
The hex-head screws holding either the panels or the base MUST be tightened with a
torque wrench (not included).
TORQUE SETTINGS:
lbf-in = Pound Force Inches
kgf-cm = Kilogram Force Centimeters
CAUTION! DO NOT OVER TORQUE
SCREWS
AS
THIS
LEAKAGE ISSUES!
TO CONFIRM THE IP65 INTEGRITY
AFTER A LAMP REPLACEMENT, TEST
FIXTURE USING THE ELATION IP
TESTER. CONTACT ELATION SERVICE
FOR MORE DETAILS.
CAUTION! THE USE OF PROTECTIVE
GLOVES AND SAFETY GOGGLES IS
STRONGLY RECOMMENDED WHILE
PERFORMING THE IP PRESSURE
TEST! AVOID PLACING YOUR FACE,
EYES,
HANDS,
PROXIMITY TO THE FIXTURE'S LENS
WHILE PERFORMING THE TEST!
Test Type
Vacuum Test
Pressure Test
CAN
CAUSE
ETC
IN
CLOSE
IP PRESSURE TESTING PARAMETERS
Low Pressure Limit
-4.35psi (-30.00 KPa)
3.62 psi (25.00 KPa)
High Pressure Limit
-5.08 psi (-35.00 KPa)
4.35 psi (30.00 KPa)
15
Hold Time
10s
10s
Advertisement
Table of Contents
