Install The Nvram Module; Install The System Cover; Installing The Nvram Module In Expansion Card Riser 1 - Dell PowerProtect DD6900 Manual

Install the NVRAM module

Prerequisites
Follow the safety guidelines listed in
About this task
NOTE: This procedure describes and illustrates NVRAM module installation in slot 2 in expansion card riser 1.
Steps
1. Pull the expansion card latch.
2. Hold the NVRAM module by its edges, and align the card edge connector with the expansion card connector in slot 2 on the
riser.
3. Insert the NVRAM module edge connector firmly into the expansion card connector until the card is fully seated.
4. If applicable, reinstall the expansion card removed from slot 1 on the riser.
5. If applicable, reconnect the cables from the expansion card in slot 1.
6. Push the expansion card latch.
Figure 35. Installing the NVRAM module in expansion card riser 1

Install the system cover

Prerequisites
Follow the safety guidelines.
Ensure that all internal cables are routed correctly and connected, and that no tools or extra parts are left inside the system.
Steps
1. Align the tabs on the system cover with the guide slots on the system.
2. Push the system cover latch down.
The system cover slides forward, the tabs on the system cover engage with the guide slots on the system and the system
cover latch locks into place.
Safety instructions on page 13.
Replace an NVRAM module 73