Table of Contents
Advertisement
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. Press the touch points on the card until the card connector is firmly seated on the system board connector.
4. Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
Figure 15. Installing the network daughter card
Install expansion card riser 2
Prerequisites
Follow the safety guidelines listed in
Safety instructions
on page 13.
Steps
To install expansion card riser 2:
a. Align the screw and tab on the riser with the screw hole and slot on the system.
b. Lower the riser into the system until the riser connector engages with the connector on the system board.
c. Using Phillips #2 screwdriver, tighten the screws to secure the riser to the system.
Figure 16. Installing expansion card riser 2
40
Replace the Network Daughter Card
Advertisement
Table of Contents
