Table of Contents
Advertisement
Figure 42. Installing the integrated storage controller card
4. Route the integrated storage controller card cable along the wall of the system.
5. Align the screws on the integrated storage controller card cable with the screw holes on the connector.
6. Using a Phillips #2 screwdriver, tighten the screws to secure the integrated storage controller card cable to the card
connector on the system board.
Figure 43. Installing the integrated storage controller card cable
Install expansion card riser 1
Prerequisites
Follow the safety guidelines.
Steps
1. Align the guide rails on the riser with the standoffs on the side of the system.
2. Lower the riser into the system until the riser connector engages with the connector on the system board.
Replace the HBA330 SAS Controller
89
Advertisement
Table of Contents
