Table of Contents
Advertisement
Figure 41. Removing the integrated storage controller cable
3. Lift one end of the card and angle it to disengage the card from the integrated storage controller card holder on the system
board.
NOTE:
Do not remove the interposer board.
4. Lift the card out of the system.
Install the integrated storage controller card
Prerequisites
Follow the safety instructions.
Steps
1. Press the touch point on the interposer board until the interposer board connector is firmly seated on the system board
connector.
2. Angle the card to engage the card with the integrated storage controller card holder on the system board.
3. Lower the card into place until the card is fully seated in the integrated storage controller card holder.
88
Replace the HBA330 SAS Controller
Advertisement
Table of Contents
